• 9 yıl önce
Maxpower 333665 Residential Grade Round .065-Inch Trimmer Line vs Taulman 645:\n\nRun over with 2013 Ford Focus, right rear tire. \nPrintrbot Simple with 0.4mm nozzle. 0.4445mm extrusion width.\nSlic3r 0.9.9 with 0.3175 layer height.\n5 permimeters. 5 top and bottom. 0.05 honeycomb infill. Solid layer every 50 layers.\nSpeed 30 perimeter, 45 infill, 15 small perimeter, accel 250.\nNo heated table. No fan. No support. 10mm brim.\nPrinted on 65% Polyester / 35% cotton fabric glued to glass with 3M Hi Strength 90 spray.\n\nResults - Trimmer line at 235C survived one run-over, but not two. Trimmer line at 240 and 245 were\nrun over twice and stayed together, but do have small cracks on a layer where the print shifted due to\nthe unheated bed. This shear line was visible before it was run over. They should be ok if made on a heated bed. \nSuggested temp is 240C for future prints.\n\nTaulman 645 - at 235C survived one run-over but failed on the second one. At 240 and 245C, survived two run-overs.\n\nFeeding T645 had multiple jams (more than 5) in Printerbot extruder and I am not sure why. Maxpower Trimmer Line\nhad no failures to feed or jams.