Check out some of the newer Plants Vs Zombies videos Ive done. Heres the Cus: \r
\r
Thats right! Im back with Plants Vs Zombies, this time Ill be creating the Peashooter. If youd like to watch the first PVZ video I did, here is the Citron: \r
\r
I created this model in Fusion 360 using forms to create most of the body shapes. Then I used sketches to carve out the final details. It took about 5 hours to model. After that I sent it to my Robo3D R1 printer. It took roughly 6 hours to print.\r
\r
Then I handed it off to my wife and she did the post processing. She sanded and cleaned any rough spots. Then she primed it with automotive fill primer before sanding again to get a really smooth finish. After that she used a combination of an airbrush and water based acrylic paints with paintbrushes to paint it. Then she sprayed it with a matte finish just to seal it up and give a little extra protection.\r
\r
Fusion 360: \r
\r
Print Settings:\r
Printer: Robo3D R1\r
Filament: Hatchbox White PLA\r
Layer Height: 0.2mm\r
Infill: 20%\r
Supports: Yes\r
Raft: Yes\r
\r
3D Files: \r
Thingiverse: \r
YouMagine: \r
PinShape: \r
Cults: \r
MyMiniFory: \r
\r
Thanks for Watching!\r
Dont forget to like and subscribe!\r
Follow me on Twitter:
\r
Thats right! Im back with Plants Vs Zombies, this time Ill be creating the Peashooter. If youd like to watch the first PVZ video I did, here is the Citron: \r
\r
I created this model in Fusion 360 using forms to create most of the body shapes. Then I used sketches to carve out the final details. It took about 5 hours to model. After that I sent it to my Robo3D R1 printer. It took roughly 6 hours to print.\r
\r
Then I handed it off to my wife and she did the post processing. She sanded and cleaned any rough spots. Then she primed it with automotive fill primer before sanding again to get a really smooth finish. After that she used a combination of an airbrush and water based acrylic paints with paintbrushes to paint it. Then she sprayed it with a matte finish just to seal it up and give a little extra protection.\r
\r
Fusion 360: \r
\r
Print Settings:\r
Printer: Robo3D R1\r
Filament: Hatchbox White PLA\r
Layer Height: 0.2mm\r
Infill: 20%\r
Supports: Yes\r
Raft: Yes\r
\r
3D Files: \r
Thingiverse: \r
YouMagine: \r
PinShape: \r
Cults: \r
MyMiniFory: \r
\r
Thanks for Watching!\r
Dont forget to like and subscribe!\r
Follow me on Twitter:
Category
📺
TV